Jon's Place

Tuesday, May 8, 2007

Foot Pressure Sensor Boards

So, I finally got around to populating one of my new foot pressure sensor boards with components. Once I figured out that my reflow oven controller was lying about what temperature it was reading, I just re-reflowed the board manually, watching for the solder to reflow.

The good news is, it worked fine, and it fits perfectly on the Bioloid foot as well. This board is a protoboard, and I will eventually get "proper" boards made from the same place that did my IMU boards.

*The BrainBot project is directed and funded by the Brain Engineering Lab and Neukom Institute


Post a Comment

Subscribe to Post Comments [Atom]

<< Home